Courtesy Lamp: Description and Operation

MODELS WITHOUT POWER DOOR LOCKS
Room Lamp
Power is supplied at all times
- through 7.5 A fuse [No.26, located in the fuse block (J/B)]
- to front room lamp terminal + and
- to rear room lamp terminal +.
With the front/rear room lamp switch in the ON position, ground is supplied through the case of the front/rear room lamp.
With one or more doors open, with the front/rear room lamp switch in the DOOR position, ground is supplied
- to front/rear room lamp terminal DR
- through front door switch LH terminal 1 and/or
- through front door switch RH, rear door switch LH/RH and/or back door switch terminal +.
Ground is supplied to back door switch terminal - through body grounds D402 and D404.

MODELS WITH POWER DOOR LOCKS
Room Lamp
Power is supplied at all times
- through 7.5 A fuse [No. 26, located in the fuse block (J/B)]
- to front room lamp terminal + and
- to rear room lamp terminal +.
With the front/rear room lamp switch in the ON position, ground is supplied through the case of the front/rear room lamp.
With the front door LH open and the front/rear room lamp switch in the DOOR position, ground is supplied
- to front/rear room lamp terminal DR
- through front door switch LH terminal 1.
With the front door RH open and the front/rear room lamp switch in the DOOR position, ground is supplied
- to smart entrance control unit terminal 35
- through front door switch RH terminal + and
- to front/rear room lamp terminal DR
- through smart entrance control unit terminal 9
- through smart entrance control unit terminal 10
- through body grounds M14 and M68.
With rear door LH/RH and/or back door open and the front/rear room lamp switch in the DOOR position, ground is supplied
- to smart entrance control unit terminal 16
- through rear door switch LH/RH and/or back door switch terminal + and
- to front/rear room lamp terminal DR
- through smart entrance control unit terminal 9
- through smart entrance control unit terminal 10
- through body grounds M14 and M68.

Room Lamp Timer Operation
When the room lamp switch is in the DOOR position, the smart entrance control unit keeps the room lamp illuminated for about 30 seconds when:
- unlock signal is supplied from multi-remote controller
- key is removed from ignition key cylinder while front door LH is closed
- driver's door is opened and then closed while ignition switch is not in the ON position.
The timer is canceled and room lamp turns off when:
- front door LH is locked with multi-remote controller, or
- ignition switch is turned ON.
The smart entrance control unit turns off the room lamp if it is left on for 30 minutes.

Map Lamp
Power is supplied at all times
- through 7.5 A fuse [No. 26, located in the fuse block (J/B)]
- to map lamp terminal +
Ground is supplied
- to map lamp terminal -
- through body grounds M14 and M68.
With map lamp switch in ON position, lamp illuminates.