Sunroof / Moonroof: Adjustments

If any gap or height difference between glass lid and roof is found, check sunroof glass fit and adjust as follows:

Gap Adjustment
1. Open shade assembly.
2. Tilt sunroof glass up.
3. Loosen sunroof glass securing nuts (3 each on left and right sides), then tilt sunroof glass down.
4. Adjust sunroof glass from outside of vehicle so it resembles "A-A" as shown in the figure.
5. Tilt sunroof glass up and down until it is adjusted to "B-B" as shown in the figure above.
6. After adjusting sunroof glass, tilt sunroof glass up and tighten nuts.
7. Tilt sunroof glass up and down several times to check that it moves smoothly.

Height Difference Adjustment
1. Tilt sunroof glass up and down.
2. Check height difference between roof panel and sunroof glass to see if it is as "A-A" as shown in the figure above.
3. If necessary, adjust it by using one of following procedures.
- Adjust by adding or removing adjustment shim(s) between sunroof glass and guide rail assembly.
- If sunroof glass protrudes above roof panel, add shims. or plain washers.at sunroof mounting bracket or stud bolt locations to adjust sunroof installation as required.