Parking Pawl Components

DISASSEMBLY





1. Slide return spring to the front of adapter case flange.
2. Remove return spring, parking pawl spacer and parking pawl from adapter case.
3. Remove parking pawl shaft from adapter case.





4. Remove parking actuator support from adapter case.

INSPECTION





Parking Pawl and Parking Actuator Support
- Check contact surface of parking rod for wear.

Rear Extension Assembly (2WD model only)
- Check for free play between companion flange and output shaft.
- Make sure bearings roll freely and are free from noise, cracks, pitting or wear.
- Check contact surface of output shaft for wear.

ASSEMBLY





1. Install parking actuator support onto adapter case.
2. Insert parking pawl shaft into adapter case.
3. Install return spring, pawl spacer and parking pawl onto parking pawl shaft.





4. Bend return spring upward and install it onto adapter case.