Manual Seat

MANUAL SEAT:

- When removing or installing the seat trim, handle carefully to keep dirt out and avoid damage.
* For Wiring Diagram, refer to "POWER SEAT".

CAUTION:
- Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
- Do not drop, tilt, or bump the side air bag module installed in the seat. Always handle it with care.
- Disconnect the side air bag, power seat switch, and heated seat harness connectors from under the seat before removing the seat.
- Disconnect the side air bag harness connector before removing the seat back. (Refer to "Side Air Bag Module".)

HEATED SEAT
- When handling seat, be extremely careful not to scratch heating unit.
- To replace heating unit, seat trim and pad should be separated.
- Do not use any organic solvent, such as thinner, benzene, alcohol, gasoline, etc. to clean trims.
* For Wiring Diagram, refer to "HEATED SEAT".