Except Models Beginning With Serial # 343314

CAUTION:
- Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
- The special bolts are coated with bonding agent while the other bolt is for ground. Do not use old bolts after removal; replace with new coated bolts.
- Check air bag diagnosis sensor unit for proper installation. Make sure that there are no deformities, dents, cracks or rust. If there are any visible signs of damage, replace with a new one.
- Check air bag diagnosis sensor unit brackets to ensure they are free of deformities and rust.
- Replace air bag diagnosis sensor unit if it has been dropped or sustained an impact.
- Check crash zone sensor for proper installation. Make sure that there are no deformities, dents, cracks or rust. If there are any visible signs of damage, replace the crash zone sensor.
- Check crash zone sensor bracket to ensure that it is free of deformities and rust.

Front Seat Belts:

REMOVAL AND INSTALLATION
1. Remove front seat.
2. Remove buckle.
3. Remove floor anchor bolt.

4. Remove adjuster cover and upper guide loop anchor bolt.
For King Cab models, remove jump seat.
Remove rear pillar lower and upper garnishes.

5. Remove guide plate.
6. Remove two adjuster bolts and adjuster assembly. A
7. Remove retractor bolt and screw.
8. Remove retractor.

NOTE: To install, reverse the removal procedure sequence.