Before VIN #343314

Removal

CAUTION: Before separating the transmission from the engine, remove the crankshaft position sensor (OBD) from the transmission. Be careful not to damage sensor edge or ring gear teeth.

NOTE: To prevent oil spills, drain transmission oil before removing transmission or insert plug into rear oil seal after removing propeller shaft.

- Be careful not to damage spline, sleeve yoke and rear oil seal when removing propeller shaft.
1. Remove battery negative terminal.
2. Remove crankshaft position sensor (OBD) from transmission upper side.
3. Remove clutch operating cylinder from transmission.
4. Remove back-up switch and park/neutral position (PNP) switch harness connectors.
5. Remove starter motor from transmission.
6. Remove propeller shaft.





7. Remove shift lever.
8. Support engine by placing a jack under oil pan.
- Do not place jack under oil pan drain plug.
9. Separate transmission from engine.

WARNING: Support manual transmission while removing it.

Installation








1. Tighten bolts securing transmission.
2. Tighten clutch operating cylinder to the specified torque.