Add Protective Coating to Fuel Sending Unit

Frontier: Add Protective Coating To Fuel Sending Unit





1. Install the Sealing Adapter (blue color adapter) onto the Fuel Sending Unit Connectors until it clicks (locks) in place. See Figure 10.

CAUTION:
When performing the following steps, use suitable protective gloves, safety glasses, or face shield.

2. Shake the Protective Coating can #KY140-9Z400 to thoroughly mix the contents.





3. Spray the Protective Coating #KY140- 9Z400 through each Adapter Tube for about two seconds (see Figure 11).

^ You will need to attach the Adapter Tube onto the Protective Coating spray can nozzle.

^ You do not have to wait for the Protective Coating to dry. Proceed to the next step.

4. Remove and discard the Sealing Adapter.

NOTE:
^ When you remove the Sealing Adapter, one or both of the connector inserts may come out of the Adapter.

^ Make sure you remove the insert(s) from the Fuel Sending Unit connector(s).

5. Re-connect the Fuel Sending Unit Harness Connectors, making sure they are securely locked into position.

6. Start the vehicle and confirm proper engine running and fuel gauge operation.