Models Beginning With Serial Number 343314

Inspecting SRS malfunctioning parts by using "AIR BAG" warning lamp - Diagnosis mode

NOTE: SRS will not enter Diagnosis mode if no malfunction is detected in User mode.




1. Open front door LH.
2. Turn ignition switch ON.
3. Press front door switch LH at least 5 times within 7 seconds after turning ignition switch ON. SRS is now in Diagnosis mode.




4. "AIR BAG" warning lamp operates in Diagnosis mode according to the following chart.

NOTE: If SRS does not enter Diagnosis mode even though malfunction is detected in User mode, go to DIAGNOSTIC PROCEDURE 11. Diagnostic Procedure 11

5. Malfunctioning part is indicated by the number of flashes (part d). Compare the number of flashes to "Warning Lamp Flash Code Chart" and locate malfunctioning part.
6. Turn ignition switch OFF and disconnect both battery cables.

WARNING LAMP FLASH CODE CHART:

7. Repair the system as outlined by the repair order in "Warning Lamp Flash Code Chart" that corresponds to the flash code.
For replacement procedure of component parts.
8. After repairing the system, go to DIAGNOSTIC PROCEDURE 7. Diagnostic Procedure 7