Models Beginning With Serial Number 343314

Inspecting SRS malfunctioning parts by using CONSULT-II - Diagnosis mode




1. Turn ignition switch OFF.
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch ON.




4. Touch "START".




5. Touch "AIRBAG".




6. Touch "SELF-DIAG [CURRENT]".




7. Self-diagnosis result is displayed on "SELF-DIAG [CURRENT]".




- If no malfunction is detected on "SELF-DIAG [CURRENT]" but malfunction is indicated by the "AIR BAG" warning lamp in User mode, go to DIAGNOSTIC PROCEDURE 4, Diagnostic Procedure 4 for diagnosing the following cases:
- Self-diagnosis result (previously stored in the memory) might not have been erased after repair.
- The SRS system is malfunctioning intermittently.

8. Touch "PRINT".
9. Compare diagnostic codes to "CONSULT-II Diagnostic Code Chart".
10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
11. Turn ignition switch OFF, then turn off and disconnect CONSULT-II and both battery cables.

CONSULT-II DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") Part 1 Of 2:

CONSULT-II DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") Part 2 Of 2:

12. Repair the system as outlined by the repair order in "CONSULT-II Diagnostic Code Chart" that corresponds to the self- diagnosis result. For replacement procedure of component parts.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 3 Diagnostic Procedure 3 for final checking