M/T Models

M/T MODELS
Power is supplied at all times:
- through 40 A fusible link (letter [e], located in the fuse and fusible link box)
- to ignition switch terminal (B).
With the ignition switch in the START position, power is supplied:
- through terminal (ST) of the ignition switch
- to clutch interlock relay terminal (5).

For models with theft warning system
With the ignition switch in the ON or START position, power is supplied:
- through 7.5 A fuse [No. [5], located in the fuse block (J/B)]
- to theft warning relay terminal (2).
With the ignition switch in the ON or START position, power is supplied:
- through 10 A fuse [No. [12], located in the fuse block (J/B)]
- to clutch interlock relay terminal (2).
If the theft warning system is triggered, terminal (1) of the theft warning relay is grounded through terminal (32) of the smart entrance control unit and ground to the clutch interlock relay is interrupted.
When the theft warning system is not operating and clutch pedal is depressed, ground is supplied:
- from clutch interlock switch terminal (2)
- to theft warning relay terminal (3)
- through theft warning relay terminal (4)
- to clutch interlock relay terminal (1).

For models without theft warning system
With the ignition switch in the ON or START position, power is supplied:
- through 10 A fuse [No. [12], located in the fuse block (J/B)]
- to clutch interlock relay terminal (2).
When the clutch pedal is depressed, ground is supplied:
- from clutch interlock switch terminal (2)
- to clutch interlock relay terminal (1).
Ground is supplied to clutch interlock switch terminal (1) through body grounds (M14) and (M68) The clutch interlock relay is energized and power is supplied:
- from terminal (3) of the clutch interlock relay
- to terminal (1) of the starter motor windings.
The starter motor plunger closes and provides a closed circuit between the battery and the starter motor. The starter motor is grounded to the engine block. With power and ground supplied, cranking occurs and the engine starts.