Models With Power Door Locks

Room Lamp
Power is supplied at all times
- through 7.5 A fuse [No.26, located in the fuse block (J/B)]
- to room lamp terminal +.
Ground is supplied at all times to smart entrance control unit terminal 10 through body grounds M14 and M6
On 2 door models, with the room lamp switch in the ON position, ground is supplied
- to room lamp terminal -
- through body grounds M14 and M68.
On 4 door models, with the room lamp switch in the ON position, ground is supplied through the case of the room lamp.
With the front door LH open and the room lamp switch in the DOOR position, ground is supplied
- to smart entrance control unit terminal 15
- through front door switch LH terminal 2
- through front door switch LH terminal 3
- through body grounds M14 and M68 and
- to room lamp terminal SW
through smart entrance control unit terminal 9.
With the front door RH open and the room lamp switch in the DOOR position, ground is supplied
- to smart entrance control unit terminal 35
- through front door switch RH terminal + and
- to room lamp terminal SW
- through smart entrance control unit terminal 9.
On 4 door models, with rear door LH/RH open and the room lamp switch in the DOOR position, ground supplied
- to smart entrance control unit terminal 16
- through rear door switch LH/RH terminal + and
- to room lamp terminal SW
- through smart entrance control unit terminal 9.

Room Lamp Timer Operation
When the room lamp switch is in the DOOR position, the smart entrance control unit keeps the room lamp illuminated for about 30 seconds when:
- unlock signal is supplied from multi-remote controller
- key is removed from ignition key cylinder while front door LH is closed
- driver's door is opened and then closed while ignition switch is not in the ON position.
The timer is canceled and room lamp turns off when:
- front door LH is locked with multi-remote controller, or
- ignition switch is turned ON.
The smart entrance control unit turns off the room lamp if it is left on for 30 minutes.

MAP LAMP
Power is supplied at all times
- through 7.5 A fuse [No.26, located in the fuse block (J/B)]
- to map lamp terminal +.
With the map lamp switch in the ON position, ground is supplied to map lamp terminal - through body grounds M14 and M68.