Models With Power Door Locks

MODELS WITH POWER DOOR LOCKS
The warning chime is controlled by the smart entrance control unit.
Power is supplied at all times
- through 7.5 A fuse [No. 28, located in the fuse block (J/B)]
- to key switch terminal 1.
Power is supplied at all times
- through 10 A fuse (with KA24DE engine) (No. 39, located in the fuse and fusible link box) or
- through 15 A fuse (with VG33E engine) (No. 39, located in the fuse and fusible link box)
- to lighting switch terminal 11.
Power is supplied at all times
- through 30 A fusible link (with KA24DE engine), 40 A fusible link (with VG33E engine) (letter f, located in the fuse and fusible link box).
- to circuit breaker terminal +
- through circuit breaker terminal -
- to smart entrance control unit terminal 1.
With the ignition switch in the ON or START position, power is supplied
- through 7.5 A fuse [No. 5, located in the fuse block (J/B)]
- to smart entrance control unit terminal 11.
Ground is supplied to smart entrance control unit terminal 10 through body grounds M14 and M68.
When a signal, or combination of signals, is received by the smart entrance control unit, the warning chime will sound.

Ignition Key Warning Chime
With the key switch in the INSERTED (key is in the ignition key cylinder) position, the ignition switch in the OFF or ACC position and the front door LH open, the warning chime will sound. A battery positive voltage is supplied
- from key switch terminal 2
- to smart entrance control unit terminal 24.
Ground is supplied
- to smart entrance control unit terminal 15
- through front door switch LH terminal 2.
Front door switch LH terminal 3 is grounded through body grounds M14 and M68.

Light Warning Chime
With the ignition switch the OFF or ACC position, front door LH open and lighting switch in parking and tail lamps ON (1ST) or headlamps ON (2ND) position, the warning chime will sound. A battery positive voltage is supplied
- from lighting switch terminal 12
- to smart entrance control unit terminal 25.
Ground is supplied
- to smart entrance control unit terminal 15
- through front door switch LH terminal 2.
Front door switch LH terminal 3 is grounded through body grounds M14 and M68.

Seat Belt Warning Chime
The warning chime will sound for approximately 6 seconds when the ignition switch is turned from OFF to ON with the driver's seat belt unfastened (seat belt buckle switch ON).
Ground is supplied
- to smart entrance control unit terminal 21
- through seat belt buckle switch terminal 1.
Seat belt buckle switch terminal 2 is grounded through body grounds M14 and M68.