Models Beginning With Serial # 343314
Repairs and Inspections Required After A CollisionTo repair the SRS, perform the following steps.
When SRS is activated in a collision:
1. Replace the air bag diagnosis sensor unit.
2. Remove the air bag modules and seat belt pre-tensioners.
3. Check the SRS components using the following table:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
4. Install new air bag modules and seat belt pre-tensioners.
5. Conduct Self-diagnosis using CONSULT-II or "AIR BAG" and "SEAT BELT" warning lamps. Refer to "Self-diagnosis" for details.
SEE DIAGNOSTIC PROCEDURE 1 AND 2.
[1][2]Component Tests and General Diagnostics
Diagnostic Procedure 2
Ensure entire SRS operates properly.
Part 1 Of 2:
Part 2 Of 2:
When SRS is not activated in a collision:
1. Check the SRS components using the following table:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
2. Conduct Self-diagnosis using CONSULT-II or "AIR BAG" and "SEAT BELT" warning lamps. Refer to "Self-diagnosis" for details.
Ensure entire SRS operates properly.