Keyless Entry Transmitter: Testing and Inspection

CONSULT-II REMOTE CONTROLLER ID SET UP PROCEDURE

NOTE: If a remote controller is lost, the ID code of the lost remote controller must be erased to prevent unauthorized use. When the ID code of a lost remote controller is not known, all ID codes should be erased. After all remote controller ID codes have been erased, the ID codes of all remaining and/or new remote controllers must be re-registered.




1. Turn ignition switch OFF.
2. Connect CONSULT-II




3. Turn ignition switch ON.
4. Press "START".




5. Touch "SMART ENTRANCE".




6. Touch "MULTI REMOTE ENT".




7. Touch "WORK SUPPORT".





8. The items shown in the figure at left can be set up.
- "REMO CONT ID CONFIR"
Use this mode to confirm if a remote controller ID code is registered or not.
- "REMO CONT ID REGIST"
Use this mode to register a remote controller ID code.

NOTE: Enter the ID code when remote controller or smart entrance control unit is replaced and additional remote controller is activated.

- "REMO CONT ID ERASUR"
Use this mode to erase a remote controller ID code.