Except Models Beginning With Serial Number 343314

Final checking after repairing SRS by using CONSULT-II- Diagnosis mode




1. After repairing SRS, connect both battery cables.
2. Connect CONSULT-II to data link connector.
3. Turn ignition switch ON.




4. Touch "START".




5. Touch "AIRBAG".




6. Touch "SELF-DIAG [CURRENT]".




7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 8. (If the malfunction was only in seat belt pre-tensioner system, go to step 11.) If any malfunction was detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 Diagnostic Procedure 2 and repair malfunctioning part completely.




8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the "AIR BAG" warning lamp even if the malfunction is repaired completely.




9. Touch "BACK" key of CONSULT-II to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".




10. Check that no malfunction is detected on "SELF-DIAG [PAST]".

NOTE: Past malfunction for seat belt pretensioner system will not be displayed on "SELF-DIAG [PAST]".

11. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode, turn off CONSULT-II, then disconnect CONSULT-II.
12. Turn ignition switch OFF.
13. Go to "SRS Operation Check" to check SRS operation by using "AIR BAG" warning lamp with User mode.