From VIN # 350001

Rear Oil Seal and Companion Flange Oil Seal Replacement

NOTE: Replace rear extension assembly as a single unit because it can not be disassembled.

1. Remove propeller shaft.





2. Remove exhaust mounting and mounting bracket.
3. Disconnect revolution and speedometer sensor harness connector.
4. Support A/T assembly with a jack.
5. Remove rear engine mounting member. Tighten rear engine mounting member to the specified torque. Refer to Engine; Specifications.
6. Remove rear extension assembly.





a. Remove parking gear and needle bearing.

CAUTION: Insert your hand between rear extension and transmission case. Detach rear extension assembly while holding parking gear and needle bearing by hand.

7. Reinstall any part removed.
- Always use new sealing parts.