Without CONSULT

1. Turn ignition switch "OFF".
2. Disconnect engine coolant temperature sensor harness connector and check resistance as shown in the figure.





3. Start engine and warm it up.
When the resistance of engine coolant temperature sensor is 1.65 to 2.4 kohms, make sure that the center of mark A is aligned with mark B as shown in the figure





- If NG, adjust by turning adjusting screw.

Lock nut:
0.98 - 1.96 N.m (10 - 20 kg-cm, 8.7 - 17.4 in-lb)

4. Start engine and warm it up.





5. When the resistance of engine coolant temperature sensor is 0.26 to 0.39 kohms, check the following.
- The center of mark A is aligned with mark C.
- The cam follower lever's roller is not touching the fast idle cam.
- If NG, replace thermo-element and perform the above inspection and adjustment again.