Without CONSULT Scan Tool

FUNCTION
- When a problem occurs in the ABS, the warning lamp on the instrument panel comes on. To start the self-diagnostic results mode, ground the self-diagnostic (check) terminal located on "Data Link Connector for CONSULT". The location of the malfunction is indicated by the warning lamp flashing.

SELF-DIAGNOSIS PROCEDURE
1. Drive vehicle over 30 km/h (19 MPH) for at least one minute.
2. Turn ignition switch OFF.





3. Ground terminal 4 of "Data link connector for CONSULT" with a suitable harness.
4. Turn ignition switch ON while grounding terminal 4. Do not depress brake pedal.





5. After 3.0 seconds, the warning lamp starts flashing to indicate the malfunction code No. (See NOTE below.)
6. Verify the location of the malfunction with the malfunction code chart. Then make the necessary repairs following the diagnostic procedures.
7. After the malfunctions are repaired, erase the malfunction codes stored in the control unit.
8. Rerun the self-diagnostic results mode to verify that the malfunction codes have been erased.





9. Disconnect the check terminal from the ground. The self-diagnostic results mode is now complete.
10. Check warning lamp for deactivation after driving vehicle over 30 km/h (19 MPH) for at least one minute.
11. After making certain that warning lamp does not come on, test the ABS in a safe area to verify that it functions properly.

NOTE: The indication terminates after 5 minutes. However, when the ignition switch is fumed from OFF to ON, the indication starts flashing again.