DTC Confirmation Procedure

NOTE:
- If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

With CONSULT
(1) Turn ignition switch "ON".
(2) Select "DATA MONITOR" mode with CONSULT.
(3) Start engine. (If engine does not run, turn ignition switch to "START' for at least 5 seconds.)

With GST
(1) Start engine. (It engine does not run, turn ignition switch to "START" for at least 5 seconds.)
(2) Select MODE 7 with GST.

No Tools
(1) Start engine. (If engine does not run, turn ignition switch to "START" for at least 5 seconds.)
(2) Turn ignition switch "OFF" and wait at least 5 seconds, then turn "ON".
(3) Perform "Diagnostic Test Mode II" (Self-diagnostic results) with ECM.