Rear Seat Belt

CAUTION:
- Do not disassemble buckle or seat belt assembly.
- Replace anchor bolts if they are deformed or worn out.
- Never oil tongue and buckle.
- If any component of seat belt assembly is questionable, do not repair. Replace the whole seat belt assembly.
- If webbing is cut, frayed, or damaged, replace seat belt assembly.
- When replacing seat belt assembly, use a genuine seat belt assembly.
- After any collision, inspect all seat belt assemblies, including retractors and other attached hard- wares (i.e., guide rail set).

Rear Seat Belt:

REMOVAL AND INSTALLATION
1. Raise up rear seat cushion.
2. Remove outer anchor bolt.
3. Remove rear side upper and lower garnish.
4. Remove anchor through-bolt.
5. Remove bolts securing rear seat belt retractor, then remove seat belt and seat belt retractor.
6. Remove each anchor bolt.