DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

TESTING CONDITION
Always perform the test at a temperature of -10°C (14°F) or higher.

With CONSULT
(1) Start engine and warm it up to normal operating temperature.
(2) Stop engine and wait at least 5 seconds.





(3) Turn ignition switch "ON" and select "EGRC-BPT/V P0402" of "EGR SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.
(4) Start engine and let it idle.
(5) Touch "START".
(6) Check the output voltage of "THRTL POS SEN" (at closed throttle position) and note it.








(7) When the following conditions are met, "TESTING" will be displayed on the CONSULT screen and the bar chart may increase. Maintain the conditions many times until "COMPLETED" appears.
CMPS.RPM (REF):
1,200 - 1,800 rpm (A/T models)
1,400 - 2,200 rpm (M/T models)
Vehicle speed:
30 - 60 km/h (19 - 37 MPH) (A/T models)
30 - 100 km/h (19 - 62 MPH) (M/T models)
B/FUEL SCHDL:
2.3 - 2.8 ms (A/T models)
2.3 - 2.7 ms (M/T models)
THRTL POS SEN:
X - (X + 0.30) V (A/T models)
X - (X + 0.35) V (M/T models)
X = Voltage value measured at step 6
Selector lever: Suitable position
- The bar chart on CONSULT screen indicates the status of this test. However, the test may be finished before the bar chart becomes full scale.
- If the bar chart indication does not continue to progress, completely release accelerator pedal once and try to meet the conditions again.
- If "TESTING" does not appear on CONSULT screen, retry from step 2.
(8) If "OK" is displayed, carry out "0VERALL FUNCTION CHECK".
Overall Function Check
If "NG" is displayed, refer to "Diagnostic Procedure".