Case Components
1. Install front cover oil seal using Tool.
- Apply multi-purpose grease to seal lip.
2. Apply sealant to mating surface of transmission case as shown at left.
- Use anaerobic liquid gasket Loctite P/N 51813, or equivalent.
3. Slide gear assembly onto adapter plate by lightly tapping it using a soft hammer.
4. Install main drive gear ball bearing snap ring.
5. Apply sealant to mating surface of adapter plate as shown.
- Use anaerobic liquid gasket Loctite P/N 51813 or equivalent.
6. Place shift forks in neutral position.
7. Install striking lever and rod onto adapter plate and align striking lever with shift brackets.
8. Install rear extension.
9. Fit main drive bearing snap ring.
10. Install striking rod lock pin.
Available Shims For Countershaft Front Bearing:
11. Select countershaft front bearing shim. Refer to the illustration for countershaft front bearing shim availability.
12. Install gasket and front cover.
13. Install return spring plugs, check ball, return springs and select check plungers.
14. Install control housing and gasket.