Final Drive Housing

1. Using three 20 mm (0.79 inch) spacers, mount final drive assembly on Tool number KV38100800 (J34310), (J25604-01).





2. Remove extension tube and differential side shaft assembly.





3. Remove differential side flange.





4. Mark side retainers for identification. Remove side retainers. Be careful not to confuse right and left side retainers and shims.





5. Extract differential case from final drive housing.





6. Remove side outer races with Tool number ST33290001 (J25810-A)
- Keep the side bearing outer races together with their respective inner cones-do not mix them up.
7. Remove side oil seal.





8. Loosen drive pinion nut with Tool number ST38060002 (J34311)
9. Remove companion flange with puller.





10. Take out drive pinion together with pinion rear bearing inner cone, drive pinion bearing spacer and pinion bearing adjusting washer.
11. Remove front oil seal and pinion front bearing inner cone.





12. Remove pinion front and rear bearing outer races with brass drift.





13. Remove pinion rear bearing inner cone and drive pinion adjusting washer with Tool number ST30031000 (J22912-01).