Removal
REMOVALAir Bag Module And Spiral Cable:
CAUTION:
^ Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait for at least 3 minutes.
^ Always work from the side of air bag module.
Air Bag Module And Spiral Cable - Removal:
1. Remove lower lid from steering wheel, and disconnect air bag module connector.
Air Bag Module And Spiral Cable - Removal:
2. Remove LH and RH side lids and ASCD steering switch (it so equipped). Using the TAMPER RESISTANT TORX (Size T50), remove left and right special bolts. The air bag module can then be removed.
Air Bag Module And Spiral Cable - Removal:
CAUTION:
^ Always place air bag module with pad side facing upward.
^ Do not attempt to disassemble air bag module.
^ The special bolts are coated with a bonding agent.
Air Bag Module And Spiral Cable - Removal:
^ Do not drop or impact air bag module. Replace air bag module if it has been dropped or sustained an impact.
^ Do not expose the air bag module to temperatures exceeding 90°C (194°F).
^ Do not allow oil, grease or water to contact the air bag module.
Air Bag Module And Spiral Cable - Removal:
3. Set steering wheel in the neutral position.
4. Disconnect horn connector and remove steering wheel nut.
5. Remove steering wheel mass damper.
6. Using steering wheel puller, remove steering wheel. Be careful not to overtighten puller bolt on steering wheel.
CAUTION: Do not tap or bump the steering wheel.
7. Remove steering column cover.
8. Disconnect air bag harness and main harness connectors.
Air Bag Module And Spiral Cable - Removal:
9 Remove the four spiral cable retaining screws. The spiral cable can then be removed.
CAUTION:
^ Do not attempt to disassemble spiral cable.
^ Do not apply lubricant to the spiral cable.