Model H190A
Prior to assembling discs and plates, properly lubricate them with limited slip differential oil.
1. Alternately position specified number of friction plates and friction discs on rear of side gear.
2. Install spring disc.
3. Install spring plate.
4. Install side gear thrust washer to differential case A.
5. Install differential case A over side gear, discs and plates assembly.
6. Install pinion mate gears, pinion shaft and thrust block to differential case A.
7. Install side gear to pinion mate gears.
8. Install pressure ring to side gear.
9. Install each disc and plate. Use same procedures as outlined in steps 1 through 3.
10. Install side gear thrust washer to differential case B.
11. Install differential case B.
- Position differential cases B and A by correctly aligning marks stamped on cases.
12. Tighten differential case couple screws.
13. Check if there is a clearance between differential cases B and A.
- If there is a clearance, use a thinner side gear thrust washer on both sides. Available side gear thrust washers: Application and ID
14. Check differential torque with Tool numbers:
(A) KV38105110
(B) KV38105120
Differential torque:
New parts: 69 - 118 Nm (51 - 87 ft. lbs.)
Used parts: 39 - 74 Nm (29 - 54 ft. lbs.)
If greater than specification, use a thinner friction disc.
If less than specification, use a thicker friction disc.
Available friction discs