Pressure Plate: Service and Repair

REMOVAL
Refer to the illustrations when servicing, noting the following:
- Check clutch cover, installed on vehicle, for uneven diaphragm spring toe height.
Uneven limit: 0.7 mm (0.028 inch)
- If out of limit, adjust the height with Tool.





INSTALLATION
- Insert Tool into clutch disc hub when installing clutch cover and disc. Be careful not to allow grease to contaminate clutch facing.
- Tighten bolts in numerical order, in two steps.
First step: 10 - 20 Nm (7 - 14 ft. lbs.)
Final step: 22 - 29 Nm (16 - 22 ft. lbs.)