Clutch Bleeding Procedure

Carefully monitor fluid level at clutch master cylinder during bleeding operation.
1. Bleed air from clutch operating cylinder according to the following procedures a through f.
a. Fill reservoir with recommended brake fluid.
b. Connect a transparent vinyl tube to air bleeder valve.
c. Fully depress and release clutch pedal several times.
d. While holding clutch pedal in the depressed position, open bleeder valve to release air.
e. Close bleeder valve, then release clutch pedal.
f. Repeat steps c through e above until brake fluid flows from air bleeder valve without air bubbles.
2. Bleed air from clutch damper by using the above procedures a through f.
3. Repeat the above bleeding procedures 1 and 2 several times.