Installation

INSTALLATION
1. Set the front wheels in the straight-ahead position.

Air Bag Module And Spiral Cable - Installation:

2. Align the turn signal cancel tab with the notch of the combination switch as shown.

Air Bag Module And Spiral Cable - Installation:

3. Rotate the spiral cable fully clockwise until tight.
4. Rotate spiral cable counterclockwise as specified below. Align the white pin with the alignment mark.

Air Bag Module And Spiral Cable - Installation:

Specified Turns For Spiral Cable

CAUTION: The spiral cable may snap during steering operation if the cable is installed improperly. Also, with the steering linkage disconnected, the cable may snap by turning the steering wheel beyond the specified number of turns. Always perform SRS self-diagnosis after installing the air bag module.

5. Connect spiral cable air bag harness and main harness connectors and tighten screws. Install steering column cover.

Air Bag Module And Spiral Cable - Installation:

6. Install mass damper on steering wheel.
7. Install steering wheel, setting spiral cable pin guide, and pulling spiral cable harness through.
8. Connect horn connector.
9. Tighten steering wheel nut.
29 - 39 N-m (3.0 - 4.0 kg-m, 22 - 29 ft-lb)

Air Bag Module And Spiral Cable - Installation:

10. Position air bag module and tighten with new special bolts.
11. Connect air bag module connector.
12. Install ASCII switch and tighten screws.
13. Install all lids.
14. Connect both battery cables.
15. Conduct Self-diagnosis to ensure entire SRS operates properly (Use CONSULT or warning lamp check). Turn steering wheel to the left end and then to the right end fully to make sure that the spiral cable is set in the neutral position.
16. If 'AIR BAG" warning lamp blinks (in User mode), it shows that the spiral cable may be snapped due to its improper position. Perform Self-diagnosis again (Use CONSULT or warning lamp check). If a malfunction is detected, replace the spiral cable with a new one.