Cylinder Block Assembly: Specifications

SPECIFICATIONS
Cylinder Block Height [1]
Standard: 246.95 - 247.05 mm (9.7224 - 9.7264 inch)
Limit [2]: 0.2 mm (0.008 inch)
Cylinder Bore Inner Diameter
Grade No. 1: 89.000 - 89.010 mm (3.5039 - 3.5043 inch)
Grade No. 2: 89.010 - 89.020 mm (3.5043 - 3.5047 inch)
Grade No. 3: 89.020 - 89.030 mm (3.5047 - 3.5051 inch)
Difference Between Cylinders: Less Than 0.05 mm (0.0020 inch)
Wear Limit: 0.2 mm (0.008 inch)
Out-Of-Round (X - Y): Less Than 0.015 mm (0.0006 inch)
Surface Flatness (Distortion)
Standard: Less Than 0.03 mm (0.0012 inch)
Limit: 0.1 mm (0.004 inch)
Taper (A - B): Less Than 0.015 mm (0.0006 inch)

[1] From crankshaft center.
[2] Total amount of cylinder head resurfacing and cylinder block resurfacing.