Procedure 4
Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode1. After repairing SRS, connect both battery cables.
Diagnostic Procedure 4 (with Consult):
2. Connect CONSULT to data link connector.
3. Turn ignition switch from OFF to ON.
Diagnostic Procedure 4 (with Consult):
4. Touch START
Diagnostic Procedure 4 (with Consult):
5. Touch AIRBAG.
Diagnostic Procedure 4 (with Consult):
6. Touch SELF-DIAG [CURRENT].
Diagnostic Procedure 4 (with Consult):
7. If no malfunction is detected on SELF-DIAG [CURRENT], repair of SRS is completed. Touch ERASE.
NOTE: Touch ERASE to erase problem (Trouble code) retained in memory. Otherwise, the diagnosis sensor unit will still sense a problem in memory when step 13 (Air bag warning lamp operation check) is performed. As a result, the "AIR BAG" warning lamp will still indicate a malfunction in the system.
Diagnostic Procedure 4 (with Consult):
^ If any problem code was displayed on SELF-DIAG [CURRENT] the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part completely.
8. Touch BACK key of CONSULT.
Diagnostic Procedure 4 (with Consult):
9. Touch SELF-DIAG [PAST].
Diagnostic Procedure 4 (with Consult):
10. Check that no self-diagnostic failure is detected on SELF-DIAG [PAST].
11. Touch BACK key of CONSULT until SELECT SYSTEM MODE appears, turn off CONSULT, then disconnect CONSULT.
12. Turn ignition switch OFF.
13. Go to DIAGNOSTIC PROCEDURE 1 to check SRS operation by using "AIR BAG" warning lamp with User mode.