Rear Axle Hub Assembly Removal and Installation (FWD)

REMOVAL AND INSTALLATION

CAUTION:

- Do not disassemble the rear wheel hub assembly.

- The magnetic encoder collects metallic particles easily, because it is magnetized. Make sure that the magnetic encoder should not collect metallic particles. Check that there is not any trouble prior to reassembling it. [Vehicles with ABS]

- When the rear wheel hub assembly is removed/installed, make sure that the magnetic encoder (integrated with inner oil seal) does not contact with surrounding parts to avoid damage. [Vehicles with ABS]

- When removing and installing the rear wheel speed sensor, make sure that its pole piece at the end does not contact with surrounding parts to avoid damage. [Vehicles with ABS]

- The part indicated with * is the bolt with friction coefficient stabilizer. In removal, replace it with a new one.









REMOVAL SERVICE POINT

[[A]] BRAKE CALIPER ASSEMBLY REMOVAL

1. Remove the brake caliper assembly with brake hose.

2. Secure the removed brake caliper assembly with a wire or other similar material at a position where it will not interfere with the removal and installation of the rear wheel hub assembly.

[[B]] REAR WHEEL HUB ASSEMBLY REMOVAL









1. If the rear wheel hub assembly is seized with the knuckle, use special tools MB990211 and MB990241 {combination (A)}, or MB990211 and MB991354 {combination (B)} to remove the rear wheel hub assembly.