Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION

CAUTION:

- Before removing the steering wheel and driver's air bag module assembly, refer to Service Precautions Service Precautions and Driver's Air Bag Module and Clock Spring Removal and Installation (Except Ralliart) [Except RALLIART] or Removal and Installation (Ralliart) [RALLIART] [Vehicles with WCM].

- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point Testing and Inspection). [Vehicles with WCM and ASC]













REMOVAL SERVICE POINT

[[A]] STEERING LOCK CYLINDER REMOVAL [VEHICLES WITH WCM]

1. Insert the key into the steering lock cylinder, and turn the ignition key to the ACC position.





2. With using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.

INSTALLATION SERVICE POINT

]]A[[ WIRELESS CONTROL MODULE [VEHICLES WITH WCM]/RECEIVER ANTENNA MODULE [VEHICLES WITH KOS] INSTALLATION

Check that the top claw of receiver antenna module is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.