Oil Pressure Sensor: Service and Repair

REMOVAL AND INSTALLATION [2.0L ENGINE NON-TURBO, 2.4L ENGINE]













Required Special Tool:

- MB992118: Oil Pressure Switch Wrench

REMOVAL SERVICE POINTS

[[A]] THROTTLE BODY MOUNTING BOLTS REMOVAL

Remove the throttle body mounting bolts and put the throttle body aside so as not to interfere the engine oil pressure switch connector disconnection.

[[B]] ENGINE OIL PRESSURE SWITCH REMOVAL

CAUTION:
The sealant is applied to the bolt. Remove the bolt with care not to break it.





Use special tool MB992118 to remove the engine oil pressure switch.

INSTALLATION SERVICE POINT

]]A[[ ENGINE OIL PRESSURE SWITCH INSTALLATION





1. Apply sealant to the engine oil pressure switch thread.
Specified sealant: Three Bond 1141J or equivalent
NOTE:
Install the engine oil pressure switch immediately after applying sealant.





2.
CAUTION:
After the installation, until a sufficient period of time (one hour or more) elapses, do not apply the oil or water to the sealant application area or start the engine.

In the same manner as removal, use special tool MB992118 to tighten the engine oil pressure switch to the specified torque.
Tightening torque: 10 ± 2 Nm (89 ± 17 in-lb)