Inspection Procedure 14

INSPECTION PROCEDURE 14: Delay occurs when the lever is shifted from "N" to "D" or "N" to "R".

COMMENTS ON TROUBLE SYMPTOM

Fluid may be insufficient or contaminated. TC-SST-ECU power supply circuit, mechatronic assembly, clutch assembly, or transaxle assembly may have a problem.

PROBABLE CAUSES

- Malfunction of TC-SST-ECU power supply circuit
- Insufficient or contaminated fluid
- Malfunction of the mechatronic assembly
- Malfunction of the clutch assembly
- Malfunction of the transaxle assembly

DIAGNOSTIC PROCEDURE

STEP 1. Check the TC-SST-ECU power supply circuit

Refer to Inspection Procedure 4.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair the TC-SST-ECU power supply circuit. (Refer to Inspection Procedure 4.)
STEP 2. Fluid check

Check for the fluid level and if no foreign material and contamination are found.

Q. Is the check result normal?

YES Go to Step 3.
NO Charge or replace the fluid.
STEP 3. Retest the system.

Q. Does a malfunction take place again?

YES Replace the transaxle assembly. (Refer to Removal and Replacement.)
NO Intermittent malfunction. How to Cope With Intermittent Malfunctions.)