Inspection Procedure 9

Inspection Procedure 9: Sound mixed with noise, only at night (AM).

The following factors can be considered as possible causes of noise appearing at night.
1. Factors due to signal conditions: Due to the fact that long-distance signals are more easily received at night, even stations that are received without problem during the day may experience interference in a general worsening of reception conditions. The weaker a station is the more susceptible it is to interference, and a change to different station or the appearance of a beating sound* may occur.
NOTE:
Beat sound*: Two signals close in frequency interfere with each other, creating a repetitious high-pitched sound. This sound is generated not only by sound signals but electrical waves as well.

2. Factors due to vehicles noise: Generator noise may be a cause.

DIAGNOSTIC PROCEDURE

STEP 1. Check that the noise still obvious even when the lights are off.

Q. Is the noise still obvious even when the lights are off?

YES Go to Step 2.

NO Go to Step 3.

STEP 2. Check that the noise fades away by the following action.

Tune to a station with a stronger wave.

Q. Does noise still exist?

YES Consult the radio manufacturer's service center.

NO This diagnosis is complete.

STEP 3. Check that the noise fades away when the vehicle harness is moved away from the radio (if the harness is not in the proper position).

Q. Does the noise fade away when the vehicle harness is moved any from the radio (If the harness is not in the proper position)?

YES Repair the wiring harness.

NO If there is more noise than other radios, consult the radio manufacturer's service center.