P0712
DTC P0712: TC-SST-ECU temperature sensor system (Output low range out)
CAUTION:
- If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
DIAGNOSTIC FUNCTION
TC-SST-ECU checks that the output of the ECU temperature sensor is normal.
DESCRIPTIONS OF MONITOR METHODS
The output of the ECU temperature is determined to be too low.
MONITOR EXECUTION
- Continuous
MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
- P0713: TC-SST-ECU temperature sensor system (Output high range out)
- P1808: TC-SST-ECU temperature, fluid temperature sensor system (Correlation error)
Sensor (The sensor below is determined to be normal)
- Not applicable
LOGIC FLOW CHARTS (Monitor Sequence)
DTC SET CONDITIONS
Check Conditions
- Voltage of battery: 8 V or more.
- Voltage of battery: 16.5 V or less.
JUDGMENT CRITERIA
- Fluid temperature: -39°C (-38.2°F) or less. (400 millisecond)
OBD-II DRIVE CYCLE PATTERN
The TC-SST-ECU temperature remains -39°C (-38.2°F) or more for 400 milliseconds.
PROBABLE CAUSES
- Malfunction of TC-SST-ECU
DIAGNOSTIC PROCEDURE
Required Special Tools:
- MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A
STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.
Q. Is the check result normal?
YES Go to Step 2.
NO Repair the CAN bus lines. CAN Bus Diagnostics Chart.) After repairing the CAN bus line, go to Step 2.
STEP 2. Check whether the DTC is reset.
30 seconds after turning ON the ignition switch, check that the diagnostic trouble code is reset.
Q. Is DTC No. P0712 set?
YES Replace the transaxle assembly. (Refer to Removal and Replacement.)
NO Intermittent malfunction. How to Cope With Intermittent Malfunctions.)