Twin Clutch-Sportronic Shift Transmission (TC-SST)

DTC P0630: VIN not Recorded

CAUTION:

- If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION

TC-SST-ECU checks that the chassis number is normal.
(TC-SST-ECU receives chassis number information from the engine control module via CAN, and write to TC-SST-ECU.)

DESCRIPTIONS OF MONITOR METHODS

The chassis number is determined to be written abnormally.

PROBABLE CAUSES

- The CAN bus line is defective.
- Malfunction of engine control module
- Malfunction of TC-SST-ECU

DIAGNOSTIC PROCEDURE

Required Special Tools:

- MB991958 Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827 M.U.T.-III USB Cable
- MB991910 M.U.T.-III Main Harness A

STEP 1. Scan tool CAN bus diagnostics

Using scan tool MB991958, diagnose the CAN bus lines.

Q. Is the check result normal?

YES Go to Step 2.
NO Repair the CAN bus lines. CAN Bus Diagnostics Chart.) After repairing the CAN bus line, go to Step 2.
STEP 2. Scan tool diagnostic trouble code

Check the engine diagnostic trouble code. Multiport Fuel Injection (MFI).)

Q. Is the DTC set?

YES Perform the relevant troubleshooting.
NO Go to Step 3.
STEP 3. Check whether the DTC is reset.

Q. Is DTC No. P0630 set?

YES Replace the transaxle assembly. (Refer to Removal and Replacement.)
NO Intermittent malfunction. How to Cope With Intermittent Malfunctions.)