C1624

DTC C1624: AWC-ECU System (Internal Malfunction)

CAUTION:

- If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION

AWC-ECU monitors the malfunction in the ECU.

DTC SET CONDITIONS

The code is set when a malfunction is found in AWC-ECU.

PROBABLE CAUSES

- Malfunction of AWC-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Scan tool CAN bus diagnostics

Using scan tool MB991958, diagnose the CAN bus lines.

Q. Is the check result normal?

YES Go to Step 3.
NO Repair the CAN bus lines. CAN Bus Diagnostics Chart.) After repairing the CAN bus line, go to Step 2.
STEP 2. Check whether the DTC is reset.

Q. Is DTC No. C1624 set?

YES Go to Step 3.
NO This diagnosis is complete.
STEP 3. Scan tool diagnostic trouble code

Check other AWC diagnostic trouble code.(Refer to Super All Wheel Control (S-AWC).)

Q. Is the DTC set?

YES Perform the relevant troubleshooting.
NO Go to Step 4.
STEP 4. Check whether the DTC is reset.

Q. Is DTC No. C1624 set?

YES Replace the AWC-ECU.(Refer to Active Center Differential (ACD).) Then go to Step 5.
NO Intermittent malfunction. How to Cope With Intermittent Malfunctions.)
STEP 5. Check whether the DTC is reset.

Q. Is DTC No. C1624 set?

YES Return to Step 1.
NO This diagnosis is complete.