Wireless Control Module (WCM)

DTC B1761: VIN code not programmed

CAUTION:

- When DTC B1761 is set, be sure to diagnose the CAN bus line.
- When replacing the ECU, always check that the communication circuit is normal.

DTC SET CONDITION

WCM sets DTC B1761 when no VIN is recorded in it.

TECHNICAL DESCRIPTION (COMMENT)

WCM determines that the abnormality is present when no VIN is recorded in it.

TROUBLESHOOTING HINTS

- Malfunction of CAN bus line
- VIN not programmed
- Malfunction of the WCM

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.





(1)
CAUTION:
To prevent damage to scan tool (MB991958), always turn the ignition switch to the "LOCK"
(OFF) position before connecting or disconnecting scan tool (MB991958).

Connect scan tool MB991958 to the data link connector.
(2)Turn the ignition switch to the "ON" position.
(3)Diagnose the CAN bus line.
(4)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the CAN bus line found to be normal?

YES Go to Step 2.

NO Repair the CAN bus line CAN Bus Diagnostics Chart).

STEP 2. Register the VIN and recheck the diagnostic trouble code.

Register VIN in WCM [ How to Perform Vehicle Identification Number (VIN) Writing] and recheck if the DTC is set.

(1)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.

(2)Check if DTC is set.

(3)Turn the ignition switch to the "LOCK" (OFF) position.

Q. Is the DTC set?

YES Replace WCM and register the ID codes (Refer to ID registration procedure manual - ID codes registration judgement table).
NO The procedure is complete.