Transfer (Change Oil)

TRANSFER OIL (CHECK OIL LEVEL AND CONDITION/CHANGE)









1. Remove the filler plug and gasket.
2. Check that the oil level is just below the lower edge of the filler plug hole.
3. Check that the oil is not excessively foul and has moderate viscosity.
4. Install the filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 Nm (24 ± 1 ft-lb)


CHANGE









1. Remove the drain plug and gasket, and gasket to drain the transfer oil.
2. Install the drain plug and new gasket, and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 Nm (24 ± 1 ft-lb)
3. Remove the filler plug and gasket, then fill the oil up to the lower edge of the filler plug hole.

Brand name: Hypoid gear oil API classification GL-5 SAE 80
Filling amount: 0.54 dm3 (0.57 qt)
4. Install the filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 Nm (24 ± 1 ft-lb)