Liftgate Window Glass: Service and Repair

REMOVAL AND INSTALLATION













REMOVAL SERVICE POINTS

[[A]] REAR FLOOR WIRING HARNESS REMOVAL





1. Cut the tape that is wrapped around the rear floor wiring harness and clip with a knife or a similar tool. Then, remove the rear floor wiring harness.
2. Remove the rear floor wiring harness from the liftgate.

[[B]] LIFTGATE WINDOW GLASS REMOVAL

Remove the liftgate window glass by the same procedures as for the windshield glass (Refer to Service and Repair).

NOTE:
Use a piano wire to remove the liftgate window glass.

INSTALLATION SERVICE POINTS

]]A[[ LIFTGATE DAM/GLASS STOPPER/FASTENER INSTALLATION

1.
CAUTION:
Before the next operation, leave the decreased parts for 3 minutes or more to dry. Do not touch the degreased parts.

Use 3M(TM) AAD Part number 8906 or equivalent to degrease the inside circumference of the liftgate window glass and the liftgate flanges.

2.




Install the liftgate dam, glass stopper, and fastener to the specified position.





3. Install the fasteners to the specified positions on the liftgate flange.

]]B[[ LIFTGATE WINDOW GLASS INSTALLATION

1. Apply the primer and adhesive.

2. Install the liftgate window glass by the same procedures as for the windshield glass (refer to Service and Repair).