Inspection Procedure 6

INSPECTION PROCEDURE 6: Noise while Turning [DIFFERENTIAL]

DIAGNOSIS

STEP 1. Check the side bearing for wear or damage.

Q. Is the side bearing worn or damaged?

YES Replace the part. Then go to Step 3.

NO Go to step 2.

STEP 2. Check the side gear, pinion gear or pinion shaft for damage.

Q. Is the side gear, pinion gear or pinion shaft damaged?

YES Replace the part. Then go to Step 3.

NO Go to Step 3.

STEP 3. Retest the system.

Q. Is the abnormal noise eliminated?

YES The procedure is complete.

NO Start over at Step 1.