Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION

CAUTION:

- Before removing the steering wheel and driver's air bag module assembly, refer to Service Precautions Service Precautions and Driver's Air Bag Module and Clock Spring Driver's Air Bag Module and Clock Spring Removal and Installation (Except Ralliart) [Except RALLIART] or Driver's Air Bag Module and Clock Spring Removal and Installation (Ralliart) [RALLIART] [Vehicles with WCM].

- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point Testing and Inspection). [Vehicles with WCM and ASC]













REMOVAL SERVICE POINT

[[A]] STEERING LOCK CYLINDER REMOVAL [VEHICLES WITH WCM]

1. Insert the key into the steering lock cylinder, and turn the ignition key to the ACC position.





2. With using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.

INSTALLATION SERVICE POINT

]]A[[ WIRELESS CONTROL MODULE [VEHICLES WITH WCM]/RECEIVER ANTENNA MODULE [VEHICLES WITH KOS] INSTALLATION

Check that the top claw of receiver antenna module is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.