Individual Component Service

INDIVIDUAL COMPONENT SERVICE

WARNING:

- If heat damage occurs during paint work, remove the SRS-ECU, the air bag modules, the clock spring, front seats, impact sensor and the seat belt with pre-tensioner.
Recheck the SRS system operability after reinstalling them.
- SRS-ECU, air bag modules, clock spring, front seats, impact sensor: 93° C
(200° F) or more

- Seat belt with pre-tensioner: 90°C (194° F) or more

- If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.

If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this section. (Front impact sensor: refer to Front Impact Sensor Removal and Installation, SRS-ECU: refer to Service and Repair, Driver's air bag modules and clock spring: refer to Driver's Air Bag Module and Clock Spring Removal and Installation (Except Ralliart) [except for RALLIART], refer to Driver's Air Bag Module and Clock Spring Removal and Installation (Ralliart) [RALLIART], Passenger's
(front) air bag module refer to Removal and Installation, Side-airbag module: refer to Removal and Installation [except for RALLIART],refer to Removal and Installation [RALLIART], Knee air bag module: refer to Knee Air Bag Module(s), Side impact sensor: refer to Removal and Installation, Curtain air bag module: refer to Curtain Air Bag Module(s) Removal and Installation, Seat belt with pre-tensioner: refer to Removal and Installation of Seat Belts With Pre-Tensioner).