Wheel Bearing End Play Check

WHEEL BEARING END PLAY CHECK

1. Remove the brake caliper assembly and the brake disk. Retain the brake caliper assembly with a wire and the like to prevent from falling (Refer to Rear Axle).





2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the looseness.
Limit : 0.05 mm (0.002 inch)
3. When the looseness exceeds the limit, replace the rear wheel hub assembly (Refer to Rear Axle).
4. After checking, install the brake disk and the brake caliper assembly, and tighten the brake caliper mounting bolt to the specified torque (Refer to Rear Axle).