Inspection Procedure 1

Inspection Procedure 1: When the Brake Pedal is Depressed, Cruise Control is not Cancelled.

COMMENT

- Malfunction of CAN bus line.

- The stoplight switch circuit is suspected.

TROUBLESHOOTING HINTS (THE MOST LIKELY CAUSES FOR THIS CASE:)

- Malfunction of CAN bus system.

- Damaged harness or connector.

- Malfunction of the stoplight switch.

- Malfunction of the ETACS-ECU.

- Malfunction of the ECM.

DIAGNOSIS PROCEDURE

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: V.C.I.

- MB991827: M.U.T.-III USB Cable

- MB991910: M.U.T.-III Main Harness A

CAUTION:
If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code (DTC) may be set. Prior to this diagnosis, diagnose the CAN bus lines CAN Bus Line Diagnostics Flow).

STEP 1. Using scan tool MB991958, diagnose the CAN bus line.





(1)
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK"
(OFF) position before connecting or disconnecting scan tool MB991958.

Connect scan tool MB991958 to the data link connector (Refer to Reading and Clearing Diagnostic Trouble Codes).
(2)Turn the ignition switch to the "ON" position.
(3)Diagnose the CAN bus line (Refer to How to Diagnose the CAN Bus Line).

Q. Is the check result satisfactory?

YES Go to Step 2.

NO Repair the CAN bus lines CAN Bus Diagnostics Chart). Then go to Step 4.

STEP 2. Using scan tool MB991958, check data list item 74: Brake light switch and item 89: Normally closed brake switch.

(1)Connect scan tool MB991958 to the data link connector (Refer to Reading and Clearing Diagnostic Trouble Codes).

(2)Turn the ignition switch to the "ON" position.

(3)Set scan tool MB991958 to data reading mode for cruise control system (Refer to How to Read Data List).

- Item 74: Brake light switch.
- When the brake pedal is depressed, the display on scan tool MB991958 should be "ON."

- When the brake pedal is released, the display on scan tool MB991958 should be "OFF."

- Item 89: Normally closed brake switch.
- When the brake pedal is depressed, the display on scan tool MB991958 should be "ON."

- When the brake pedal is released, the display on scan tool MB991958 should be "OFF."

Q. Is the switch operating properly?

YES Go to Step 3
NO Repair the stoplight switch system (Refer to DTC 22, Diagnostic Trouble Code Procedures - DTC 22: Stoplight Switch System). Then go to Step 4.
STEP 3. Check the symptoms.

Q. When the brake pedal is depressed, is the cruise control cancelled?

YES It can be assumed that this malfunction is intermittent How to Cope With Intermittent Malfunctions).
NO Replace the ECM [ Removal and Replacement] [2.0L ENGINE Non-turbo], [ Removal and Replacement] [2.0L ENGINE Turbo], or [ Removal and Replacement] [2.4L ENGINE]. When the ECM is replaced, register the encrypted code (Refer to ID registration procedure manual - ID codes registration judgement table) [Vehicle with WCM installed]. Then go to Step 4.
STEP 4. Check the symptoms.

Q. When the brake pedal is depressed, is the cruise control cancelled?

YES The procedure is complete.
NO Return to Step 1.