Inspection Procedure 1

INSPECTION PROCEDURE 1: Vehicle Pulls to One Side when Brakes are Applied

DIAGNOSIS

STEP 1. Check for oil, water, etc., on the pad contact surface of all brakes.

Q. Is oil, water, etc., on the pad contact surface?

YES Replace the part and determine the source/cause of foreign material.
Then go to Step 5.

NO Go to Step 2.

STEP 2. Check disc brake pistons for smooth operation.

(1)With engine not running, depress the brake pedal rapidly several times to deplete booster vacuum reserves.

(2)Test each disc brake assembly one at a time.

.....
Remove the lower caliper bolt, then remove caliper from mount.

.....
Have an assistant slowly depress the brake pedal. Confirm piston(s) extend slowly and smoothly with no jumpiness. Repeat for each disc brake assembly.

Q. Do (does) the piston(s) move correctly?

YES Go to Step 3.

NO Disassemble and inspect the brake assembly {Front: refer to Disassembly and Assembly [15-Inch Front Disc Brake] [15-inch front disc brake], Disassembly and Assembly [16-Inch Front Disc Brake (Except Ralliart)] [16-inch front disc brake (Except RALLIART)] or Disassembly and Assembly [16-Inch Front Disc Brake (Ralliart)] [16-inch front disc brake (RALLIART)], Rear: refer to Rear Disc Brake Assembly Disassembly and Assembly [14-Inch Rear Disc Brake] [14-inch rear disc brake], Rear Disc Brake Assembly Disassembly and Assembly [16-Inch Rear Disc Brake (Except Ralliart)] [16-inch rear disc brake (Except RALLIART)] or Rear Disc Brake Assembly Disassembly and Assembly [16-Inch Rear Disc Brake (Ralliart)] [16-inch rear disc brake (RALLIART)]}. Then go to Step 5.

STEP 3. Check brake disc(s) for run-out.

Refer to Brake Disc Check.

Q. Is run-out outside of specifications?

YES Repair or replace the brake disc(s) as necessary. Then go to Step 5.

NO Go to Step 4.

STEP 4. Check brake discs for correct thickness.

Refer to Brake Disc Check.

Q. Is the thickness outside of specifications?

YES Repair or replace the brake disc(s) as necessary. Then go to Step 5.

NO Perform the brake line bleeding. Then go to Step 5.

STEP 5. Retest the system.

Q. Is the symptom eliminated?

YES The procedure is complete.

NO Start over at Step 1. If a new symptom appears, refer to the appropriate symptom chart.