Radio and CD Player
DTC U0019: Bus off (CAN-B)
CAUTION:
If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, always diagnose the CAN bus lines.
CAUTION:
Before replacing the radio and CD player, be sure to check that the power supply circuit, ground circuit, and communication circuit are normal.
TROUBLE JUDGMENT
When the radio and CD player is returned from the bus off state, or when the bus error is indicated to the radio and CD player state, the DTC U0019 (CAN-B) is set.
TROUBLESHOOTING HINTS
The radio and CD player, power supply for the radio and CD player, ground circuit, or CAN bus line may have a problem.
TROUBLESHOOTING HINTS
- Malfunctions of radio and CD player
- Malfunction of CAN bus line wiring harness and connector
DIAGNOSIS
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
(1)
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) Reading and Clearing Diagnostic Trouble Codes."
(2)Turn the ignition switch to the "ON" position.
(3)Diagnose the CAN bus line.
(4)Turn the ignition switch to the "LOCK" (OFF) position.
Q. Is the CAN bus line found to be normal?
YES Go to Step 2.
NO Repair the CAN bus line CAN Bus Diagnostics Chart).
STEP 2. Recheck for diagnostic trouble code.
Check again if the DTC is set to the radio and CD player.
(1)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(2)Check if DTC is set.
(3)Turn the ignition switch to the "LOCK" (OFF) position.
Q. Is the check result normal?
YES Replace the radio and CD player.
NO The trouble can be an intermittent malfunction How to Cope With Intermittent Malfunctions).