C1063

DTC C104B: Abnormality in FL wheel inlet valve system
DTC C104F: Abnormality in FR wheel inlet valve system
DTC C1053: Abnormality in RL wheel inlet valve system
DTC C1057: Abnormality in RR wheel inlet valve system
DTC C105F: Abnormality in FL wheel outlet valve system
DTC C1063: Abnormality in FR wheel outlet valve system
DTC C1067: Abnormality in RL wheel outlet valve system
DTC C105B: Abnormality in RR wheel outlet valve system

CAUTION:

- If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines CAN Bus Diagnostics Chart).

- Whenever ECU is replaced, ensure that the CAN bus lines are normal.

CIRCUIT OPERATION

- ABS-ECU contains the power supply circuit (terminal No.26) for the solenoid valve.
The solenoid valve is energized by the valve relay, which is incorporated in ABS-ECU.

- The valve relay, which is incorporated in ABS-ECU, is always energizing the solenoid valve unless the initial check is in progress when the ignition switch is turned on, or the recurrent system check is in progress.

- ABS-ECU activates the solenoid valve by turning on its driving transistor.

DTC SET CONDITIONS

These DTCs will be set under the conditions below:

- The solenoid valve is not energized even after ABS-ECU has turned on the driving transistor (Open circuit is present in the power supply circuit to the ABS-ECU solenoid valve, or the valve relay has failed).

- After ABS-ECU has turned off the driving transistor, the solenoid valve still remains energized (short in the solenoid valve circuit).

- When a solenoid valve failure is detected

PROBABLE CAUSES

- ABS-ECU malfunction

DIAGNOSIS

Required Special Tools:

- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)

- MB991827: M.U.T.-III USB Cable

- MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, diagnose the CAN bus lines.

Use scan tool to diagnose the CAN bus lines.

Q. Is the check result normal?

YES Go to Step 3.
NO Repair the CAN bus lines CAN Bus Diagnostics Chart).
On completion, go to Step 2.
STEP 2. DTC recheck after resetting CAN bus lines

Q. Is the relevant DTC set?

YES Go to Step 3.
NO The procedure is complete.
STEP 3. Check whether the DTC is reset.

Erase the diagnostic trouble code.

Q. Is the relevant DTC set?

YES Replace the hydraulic unit (ABS-ECU) (Refer to Anti-Lock Braking System (ABS)).
Then go to Step 4.
NO Intermittent malfunction How to Cope With Intermittent Malfunctions).
STEP 4. Check whether the DTC is reset.

Erase the diagnostic trouble code.

Q. Is the relevant DTC set?

YES Return to Step 1.
NO The procedure is complete.