Fuel Pressure Release: Service and Repair

REDUCE PRESSURIZED FUEL LINES

WARNING:
When removing the fuel pipe, etc., release fuel pressure to prevent fuel spray.

1. Remove the rear seat cushion assembly Rear Seat Assembly Removal and Installation).





2. Remove the hole cover.





3. Disconnect the fuel pump module connector.
4. After starting the engine and letting it run until it stops naturally, turn the ignition switch to the "LOCK" (OFF) position.
5. Crank the engine for two seconds or more.
6. If the engine does not start, turn the ignition switch to "LOCK" (OFF) position.
7. If the engine starts, stop it naturally and turn the ignition switch to "LOCK" (OFF) position.
8. Connect the fuel pump module connector.





9. Install the hole cover.
10. Install the rear seat cushion assembly Rear Seat Assembly Removal and Installation).